Telex NEO-10 User Manual

Model NEO-10 Version 1.0 Technical Manual November 26, 2003 PN: 803968

10 3.4 Multicast Setup A single multicast address is employed by NEO for the purpose of updating consoles of changes in the Relays and Inputs. NEO

113.5 Debounce Input Settings The Debounce hyperlink will open the screen below. Each of the 10 inputs can have its own input debounce time. This

12 3.6 Echo Packet The Echo Packet function allows the system to operate on networks that do not support multicast. A typical application might be a

13 Figure 7 - Echo Packet Setup

14 3.7 Clone From Other NEO The Clone function allows for the parameters of one NEO to be copied to another over the network. Simply enter the IP ad

153.8 PIN Change The PIN number is the password required to enter the setup mode of the NEO. The default is no PIN number. The PIN number is a 4 d

16 3.9 Save Changes to EEPROM As each group of settings are changed and submitted, they still must be saved to EEPROM to be stored permanently. Some

174 BILL OF MATERIAL AND SCHEMATICS

REVISIONSREVDESCRIPTION ECO NO DATEAPPD1 PROTOTYPE09/16/03This drawing, written description or specification Is a proprietary product of TELEX, Lincol

ITEMNEWQTYTYPE DESCRIPTION PART NO. DESIGNATOR114 CAP 10uf 16vTANT 3528 B 102877065TC1 C3 C11 C18 C19 C68 C71 C73 C74 C123 C124 C131 C162 C329215 CAP

2 Table of Contents 1 INTRODUCTION...

ITEMNEWQTYTYPE DESCRIPTION PART NO. DESIGNATORThis drawing, written description or specification Is a proprietary product of TELEX, Lincoln, NE, and s

ITEMNEWQTYTYPE DESCRIPTION PART NO. DESIGNATORThis drawing, written description or specification Is a proprietary product of TELEX, Lincoln, NE, and s

18 5 Warranty, Service, Repair, and Comments Important! Be sure the exact return address and a description of the problem or work to be done are enc

31 Introduction The NEO-10 device is a network based Input Output device. Within its enclosure are 10 DPDT relays with all 6 contacts of the relays

4 2 Connecting NEO to the World NEO has a total of three different ports that are used to connect it to the world. Likely, the first port that will

53 Software Configuration of NEO Setup of the NEO is almost entirely done using a web browser. The first step required during setup is to assign t

6 At the main Hyper Terminal screen type uppercase S then <enter>. Enter “technobabble” for the factory password.

7 A = The board serial number and case serial number should match. B = Do you want to reset the PIN number programmed into NEO. C = Current IP addr

8 3.2 General Setup via Web Pages The majority of the setup of the NEO is completed through the Ethernet port. Once the steps of 3.1 have been compl

9Once all parameters are set, press the Submit button to send them back to the NEO from the web browser. The parameters are not updated until they