Telex AUDIOCOM MS-2002 User Manual download pdf (Page 28)

Connector Type: Uses same connectors as for balanced mode, above, but

without pinouts modified by BAL/UNBAL switch on back panel as

follows

XLR-3 Unbalanced Configuration Pinouts

Pin 1 Common

Pin 2 +24 VDC input

Pin 3 Intercom audio high

XLR-6 Unbalanced Configuration Pinouts

Pin 1 Common

Pin 2 Local Power (12 to 15 VDC, 65 to 150mA)

Pin 3 Channel 1 +24 VDC input

Pin 4 Channel 1 Intercom audio high and DC call

Pin 5 Channel 2 +24 VDC input

Pin 6 Channel 1 Intercom audio high and DC call

PA Output

Output Level:

235 mV

RMS nominal

Connector Type: 3.5mm Stereo Phone Jack

Tip: PA output high

Ring: Not used

Sleeve: Common

Speaker Output

Output Level:

0dB nominal (1.0V

RMS)

Output Impedance:

1000 Ohm nominal

Frequency Response:

200Hz to 8kHz +1/-3dB

Connector Type: RCA Phono Jack

Tip: Speaker output high

Sleeve: Common

Expansion Input/Output

Type:

3.5mm stereo phone jack

Tip: Tip Output

Ring: Listen input

Sleeve: Common

Headphone Amplifier

Voltage Gain:

30 ±3dB

Maximum Output:

250mW ±10% into 150 Ohm, 65mW ±10% into 600 Ohm

Frequency Response:

200Hz to 8kHz +1/-3dB

Incoming Call Beep Tone:

2kHz, at the headphones

Total Harmonic Distortion:

Less than 0.2% at 200mW

Sidetone:

18 ±dB, adjustable

1 2 ... 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments

Telex AUDIOCOM MS-2002 User Manual Page 28

Comments to this Manuals

Related products and manuals for Tools Telex AUDIOCOM MS-2002