Telex MCE325 User Manual download pdf (Page 10)

1-2 MCE325 User Instructions

Front Panel Features

Channel Selector and Operation Buttons

These buttons have two modes of operation: standard operating mode and program, or setup,

mode. The printing on the face of each button indicates its function in standard operating mode;

printing under each button indicates its setup mode function. (See Section 3 for operation and

programming instructions.) An LED located above each button provides status information.

The MCE325 is factory pre-programmed for two-channel operation, with each channel having

one talk and one listen button. However, the MCE325 may also be programmed so that each

channel selector button controls both talk and listen for a single channel, permitting operation of

up to four intercom channels. Additionally, users may wish to customize the identification of

channels. With this in mind, a button kit has been supplied with the MCE325 to allow you to

customize the button labeling to suit your particular application. Figure 1.11 shows the available

button caps as well as some typical button configurations.

NOTE

The standard buttons are opaque. As a result, the front panel LED’s may not be visible when

viewing the MCE325 from a low angle (such as when it is mounted high in an equipment rack).

As a remedy for this problem, clear buttons are available that allow the LED light to pass through.

(Order RTS™ part no. 9000-2698-800)

Volume Controls

CH1 (VOL 1): This control adjusts the volume of channels 1 and/or 3 to the left headphone when

stereo headphones are used. It adjusts the mono mix level of these channels when monaural

headphones or an external speaker is used.

CH2 (VOL 2): This control adjusts the volume of channels 2 and/or 4 to the right headphone

when stereo headphones are used. It adjusts the mono mix level of these channels when monaural

headphones or an external speaker is used.

PGM VOL: This control adjusts the mono mix of program A and program B (input at the rear

panel and assigned via internal programming) to the headphones and external speaker.

Sidetone Nulling Trimmers

These trimmers are adjusted to prevent acoustic feedback when using a panel microphone along

with an external speaker.

Connections, Inputs and Outputs

Front Panel

DYNamic MIC HEADSET: This connector accepts a stereo-earphone, dynamic-microphone

headset (with or without a mic on/off switch).

CARBon MIC HEADSET: This connector accepts a standard 3-conductor, ¼-inch phone plug.

The necessary phantom power is provided to power a carbon microphone or its electronic

equivalent.

Panel Microphone Jack

The MCE325 may be optionally fitted with a gooseneck panel microphone by removing the

blanking plug located in the upper-right corner of the front panel. The panel microphone jack

accepts specially made gooseneck microphones (MCP-90 series), which are available from RTS.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 84 85

No comments

Telex MCE325 User Manual Page 10