Telex MCE325 User Manual download pdf (Page 28)

2-8 CSI-200 User Instructions

Electrical Installation

AC Power and Fuse

The Model MCE325 is pre-wired for either 115 or 230 VAC operation, and the appropriate fuse is

already installed. The MCE325 uses a 0.5A Slo-Blo fuse for 115 volt operation, or a 0.25A Slo-

Blo fuse for 230 volt operation. (A fused external DC source may be used instead of AC power if

desired. (See “External DC Power Source”.)

Intercom Lines J8, J9, and J10

General

Intercom line connectors J8 and J9 are parallel-wired for loop-through connection to other

intercom stations. These connectors are used for connection of two-wire lines to channels one and

two (full-duplex operation), or for connection of four-wire channel A output (channel A input is

connected at the auxiliary connector).

Intercom line connector J10 is used for connection of two-wire lines to channels three and four

(full-duplex operation), or for connection of four-wire channel B output (channel B input is

connected at the auxiliary connector).

Connector Pin-outs

Four-wire Output Termination

Figure 2.4

4-wire output terminations.

When four-wire outputs are used, termination resistors must be installed for proper operation. The

output amplifiers are current sources, and the output level is determined by the terminating

Table 2.4

Connectors J8 and J9.

PIN # FUNCTION

1 Common (low side of line)

2 Two-wire CH 1 or four-wire CH A high output

3 Two-wire CH 2 or four-wire CH A low output

Table 2.5

Connection J10

PIN # FUNCTION

1 Common (low side of line)

2 Two-wire CH 3 or four-wire CH B high output

3 Two-wire CH 4 or four-wire CH B low output

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 84 85

No comments

Telex MCE325 User Manual Page 28